Renewals

Certified Rigger Level 1 RENEWAL (ACS510)


Description
CALL (941)730-6576 if you need assistance.

Successful completion of this course renews your Certified Rigger Level 1 designation for another 2 years. You must have a current AMC&S Certified Rigger Level 1 certification to be eligible to renew your designation.


NOTE: If it is past the 30 day grace period of the expiration of your certification then you must re-test. To do so you should exit and purchase our Certified Rigger Level 1 course which includes the written and practical exams.


NOTE: New regulations went into effect on December 17, 2022 - under ASME B30.5-3.1.2.2 Qualified Riggers (“Certified”) are required when working with any type of Mobile Crane including Crawler Cranes, Locomotive Cranes, Wheeled Cranes and any variations of cranes that retain the same fundamental characteristics of 1 ton or more. Qualified Riggers must pass written and practical examinations (“Certified”).


Please note: Although ASME defines this person a Qualified Rigger, OSHA is very clear that the employer is the only one that can determine if you are qualified to perform the rigging activities at hand.

Content
  • Certified Rigger Level 1
  • Trainer/Student Interview Requirement
  • Disclaimer and Table of Contents
  • Introduction to Certified Rigger Level 1
  • Terms & Definitions
  • Fundamentals of Lifting
  • Two Block Chuck
  • Weight & Center of Gravity
  • Jacking Practices
  • Introduction Quiz
  • Section 1 Safety Standards and Regulations
  • Safety Standards & Regulations
  • Section 1 Quiz
  • Section 2 Inspections
  • Inspections
  • Section 2 Quiz
  • Free Rigging
  • Section 3 Wire Rope Slings
  • Wire Rope Slings
  • Section 3 Quiz
  • Section 4 Chain Slings
  • Chain Slings
  • Section 4 Quiz
  • Section 5 Synthetic Web Slings
  • Synthetic Web Slings
  • Section 5 Quiz
  • Section 6 Round Slings
  • Round Slings
  • Section 6 Quiz
  • Section 7 Mesh Slings
  • Mesh Slings
  • Section 7 Quiz
  • Section 8 Rigging Hardware and Hooks
  • Rigging Hardware - Hooks
  • Section 8A Quiz
  • Turnbuckles
  • Section 8B Quiz
  • Rigging Hardware - Wire Rope Clips
  • Section 8C Quiz
  • Section 9 Plate Clamps, Lifting Magnet and Vacuum Lifts
  • Clamps and Lifts
  • Section 9 Quiz
  • Section 10 Hooks
  • Hooks
  • Section 10 Quiz
  • Section 11 Lifting Beams and Spreader Beams
  • Below the Hook Lifters
  • Section 11 Quiz
  • Section 12 Manual Hoists
  • Manual Hoist Inspections
  • Section 12 Quiz
  • Section 13 WLL, Lifts and Rigging Plans
  • Working Load Limit & Rigging Plans
  • Section 13A Quiz
  • Basic Hitches
  • Section 13B Quiz
  • Sling Lifting Capacity
  • Section 13C Quiz
  • Rigging Loads
  • Section 13D Quiz
  • Angles & Load Stability
  • Section 13E Quiz
  • Section 14 Exercises
  • Sling and Hardware Exercises
  • Vertical Chain Sling Exercise
  • Vertical Web Sling Exercise
  • Sling Tension Exercise
  • Wire Rope Sling Exercise
  • Knots & Planning Your Lift
  • Section 14B Quiz
  • Power Line and Site Safety
  • Section 14C Quiz
  • Section 15 Practical Instruction
  • Practical Instruction for Qualified Riggers
  • Practice Exam
  • Section 16 CERTIFIED RIGGER EXAMINATIONS
  • Student Interview Verification Form
Completion rules
  • All units must be completed
  • Leads to a certificate with a duration: 2 years